3-PAGE VECTOR A4 STUDIO
EPA 40 CFR Part 84 & Section 608 Quick Reference Summary Citation: 40 CFR Part 84, Subpart C (AIM Act >= 15 lbs)

R-32 Commercial Walk-In Freezer Split System — EPA Part 84 Leak Rate Calculator & Repair Clock

For a Commercial Walk-In Freezer Split System charged with 24 lbs 0 oz (24.00 lbs) of R-32 (GWP 675, ASHRAE Class A2L), the 2026 EPA 40 CFR Part 84 maximum leak rate threshold is 20% (Commercial Refrigeration (20% Max EPA Leak Rate)). Adding more than 4 lbs 13 oz (4.80 lbs) in 12 months (Rolling Average) or 1 lbs 3 oz (1.18 lbs) within 90 days (Annualizing) triggers a mandatory 30-day repair clock and 10-day follow-up verification test.

Exact R-32 Addition Weights That Trigger a 30-Day EPA Repair on a Commercial Walk-In Freezer Split System

Pre-computed for a nominal factory full charge of 24 lbs 0 oz under the 20% Commercial Refrigeration (20% Max EPA Leak Rate) limit:

Days Since Last Charge Annualizing Multiplier Max Addition Before 20% Trigger (Annualizing) Max 12-Mo Addition (Rolling Avg) 125% Chronic Leaker EPA Report Limit
30 Days 12.17x 0 lbs 6 oz (0.39 lbs) 4 lbs 13 oz (4.80 lbs) 30 lbs 0 oz (30.00 lbs)
60 Days 6.08x 0 lbs 13 oz (0.79 lbs) 4 lbs 13 oz (4.80 lbs) 30 lbs 0 oz (30.00 lbs)
90 Days 4.06x 1 lbs 3 oz (1.18 lbs) 4 lbs 13 oz (4.80 lbs) 30 lbs 0 oz (30.00 lbs)
180 Days 2.03x 2 lbs 6 oz (2.37 lbs) 4 lbs 13 oz (4.80 lbs) 30 lbs 0 oz (30.00 lbs)
270 Days 1.35x 3 lbs 9 oz (3.55 lbs) 4 lbs 13 oz (4.80 lbs) 30 lbs 0 oz (30.00 lbs)
365 Days 1.00x 4 lbs 13 oz (4.80 lbs) 4 lbs 13 oz (4.80 lbs) 30 lbs 0 oz (30.00 lbs)

R-32 (Difluoromethane (R-32 Single Component)) Thermodynamic & Safety Profile

Global Warming Potential
675 (AR4 100-Yr)
ASHRAE 34 Safety Class
Mildly Flammable (ASHRAE Class A2L — Spark-Free Recovery Required)
Charging Phase & Glide
Liquid or Vapor (Single-Component Zero Glide) (0 degF Glide)
Lubricant & Thread Spec
POE / PVE Synthetic Oil • Left-Hand Thread (LH CGA 164)

R-32 Saturation Pressure-Temperature (PT) Reference (PSIG)

-10 degF 37.2 PSIG
0 degF 49.2 PSIG
20 degF 79.8 PSIG
40 degF 121 PSIG
60 degF 173.9 PSIG
85 degF 259.6 PSIG
105 degF 347.6 PSIG
125 degF 455.4 PSIG

R-32 DOT Recovery Cylinder 80% Maximum Safe Fill Weights (at 130 degF)

DOT Cylinder Specification Water Capacity (WC) Typical Tare Wt R-32 SG @ 130 degF Max 80% Net R-32 Charge Max Safe Gross Scale Reading
30-lb DOT-4BA400 Refrigerant Recovery Cylinder 26.2 lbs 17.8 lbs 0.82 17 lbs 3 oz (17.19 lbs) 35 lbs 0 oz (34.99 lbs)
50-lb DOT-4BA400 Refrigerant Recovery Cylinder 47.6 lbs 28.5 lbs 0.82 31 lbs 4 oz (31.23 lbs) 59 lbs 12 oz (59.73 lbs)
125-lb DOT-4BW400 Commercial Recovery Cylinder 123.0 lbs 62.0 lbs 0.82 80 lbs 11 oz (80.69 lbs) 142 lbs 11 oz (142.69 lbs)

Engineering & EPA Part 84 Field Compliance Protocol for R-32 Commercial Walk-In Freezer Split System

Under the US EPA AIM Act Subsection (h) rule (40 CFR Part 84, Subpart C) effective January 1, 2026, any Commercial Walk-In Freezer Split System operating with R-32 (Difluoromethane (R-32 Single Component), AR4 GWP 675) holding 15.0 pounds or more of refrigerant is subject to mandatory federal leak rate calculations and 3-year recordkeeping. With a nominal factory charge of 24 lbs 0 oz (24.00 lbs), this Walk-In Freezer System exceeds the 15-pound threshold by 9.0 lbs and falls under the 20% maximum annual leak rate limit for Commercial Refrigeration (20% Max EPA Leak Rate).

CRITICAL A2L FIELD PROTOCOL: R-32 is classified by ASHRAE Standard 34 as Class A2L (Mildly Flammable (ASHRAE Class A2L — Spark-Free Recovery Required)). Service technicians working on a Walk-In Freezer System must use an A2L-rated recovery machine (spark-free / brushless motor compliant with UL 1963), connect via a Left-Hand Thread (LH CGA 164), and verify proper operation of the unit's factory Refrigerant Detection System (RDS) sensor and mitigation damper before returning the appliance to service.

CHARGING & PINPOINT VERIFICATION: With a negligible glide of 0 degF and a normal boiling point of -61 degF, R-32 maintains stable saturation pressures (121 PSIG at 40 degF evaporator coil; 347.6 PSIG at 105 degF condensing temperature). During EPA initial and follow-up verification tests, inspect High-discharge-temperature compressor discharge service valves, VRF branch selector flare connections, and outdoor reversing valves..

Frequently Asked Questions: R-32 Walk-In Freezer System Compliance

How many pounds or ounces of R-32 trigger an EPA leak repair on a Commercial Walk-In Freezer Split System?

For a Commercial Walk-In Freezer Split System holding 24 lbs 0 oz (24.00 lbs) of R-32 under the 20% Commercial Refrigeration (20% Max EPA Leak Rate) limit, adding more than 4 lbs 13 oz (4.80 lbs) over a rolling 365-day period triggers the mandatory 30-day EPA repair clock. Under the Annualizing Method, if only 90 days have elapsed since the last charge, adding just 1 lbs 3 oz (1.18 lbs) will exceed the 20% annualized threshold.

Is a Commercial Walk-In Freezer Split System using R-32 regulated under the 2026 EPA AIM Act 15-pound rule?

Yes. Because R-32 has a GWP of 675 (greater than 53) and this Walk-In Freezer System holds 24 lbs 0 oz (24.00 lbs) (at or above the 15-pound threshold effective January 1, 2026 under 40 CFR Part 84), the building owner and servicing contractor must calculate leak rates on every addition, perform initial and 10-day follow-up verification tests, and keep records for 3 years.

What triggers a mandatory EPA Chronic Leaker Report for this R-32 Walk-In Freezer System?

Under 40 CFR 84.106(j), if cumulative refrigerant additions to this 24 lbs 0 oz (24.00 lbs) Walk-In Freezer System reach or exceed 125% of its full charge (30 lbs 0 oz (30.00 lbs)) within a single calendar year, the owner/operator must submit a Chronic Leaker Report to the EPA by March 1 of the following year describing the root cause and corrective plan.